DBI SALA 1500058 Tool Lanyard is a 10 lb. (4.5kg) Capacity, 36.00" Length.

Used in combination with DBI SALA™ Attachment Points, Trigger2Trigger Tool Lanyards are an economical tethering solution for most hand tools. Pull down on the trigger to open the dual-hooked connector, then release once latched to a tool. Trigger2Trigger Tool Lanyards come in varying lengths and are load-rated for 10 lb. User-friendly thumb triggers are provided on both ends of the lanyard. Designed to be used with most small hand tools.

Features and Specs:

• User-friendly thumb activated triggers
• 10 lb. (4.5 kg) capacity
• 36 in. (91.44 cm) in length
• Available in several lengths
• Pack of 10

For industrial/occupational use only. Not for consumer sale or use 

Disclaimer: 3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert. For additional product information, visit www.3M.com.